If your Ford F250 is running hot, it is a serious problem. If it gets too hot, it leads to overheating. A hot engine is usually caused by a few different things, such as the thermostat, water pump, radiator, or outside conditions.
Ford F250 Running Hot Symptoms
Obviously, the main symptom of running hot is going to be the engine temperature gauge or warning light is on. This article is written to help you figure out why your F250 may by running hot. If it’s overheating, it would be better if you read this article: Ford F250 Overheating Diagnosis. An overheating vehicle can potentially have other symptoms as well. But, the causes are usually the same.
Common Symptoms of an engine running hot include:
- Bad Smell– The accumulated oil and grease on your F250’s engine can smoke when it’s heated more than it usually is. You may also smell engine coolant. Engine coolant has a sweet smell. If you are smelling it, you’re pretty close to overheating (if you haven’t already).
- High Temp Gauge– The bad smell and high temperature gauge should be about the only symptoms your F250 should have. Anything else would be a symptom of overheating.
F250 Running Hot Causes
Here are some of the most common reasons that your F250 would run hot:
1. Low Engine Coolant
The very first place that you would want to check if your F250 is running hot is going to be the engine coolant. It’s highly likely that the coolant level is low, and it’s the easiest thing to check, so start there.
You almost never have to take off the radiator cap to check the coolant level. Modern vehicles use an overflow container. There’s always coolant in there and it fills up a bit when the engine warms up. It’ll have a line that says where the coolant should be if it the engine is hot or cold.
If your engine is low on coolant, the overflow container should be empty all of the way, not just a little bit. You’re going to need the proper Ford approved coolant and you’re going to have to fill it back up.
It’s important that you don’t pour a bunch of coolant in your F250 while the engine is hot. If it’s starving for coolant, the dramatic temperature change can cause engine damage. It’s best to fill the overflow, let the engine cycle it through for a few minutes and start over again. This should be done with the engine cool.
2. Radiator Fan
Depending on the model year and the engine, your F250 could have a clutch fan or an electric fan. A bad fan can cause your engine to run hot. The fan pushes air over the radiator to keep it running cool.
When you are out on the highway, the wind passing over the radiator is more than enough to keep it cool. You will notice that a fan is not working properly when the vehicle isn’t moving very fast. If the engine begins to cool off when you get onto the highway and into “clean” air, it very well could be the fan.
It’s easy to tell if the radiator fan is bad or not. When your engine is running warm, that fan should be on. With the vehicle in park, go ahead and pop the hood. The fan should be moving. If it’s not, it’s almost certain that you need a new fan. It can also be the thermostat that tells the fan when to come on or off that could be at fault. It’s much more likely to be the fan though.
3. Radiator Issues
Your F250’s water pump pushes coolant through the engine. The coolant exits the engine and enters the radiator. Simply put, the radiator is a series of finned tubes that cool the coolant so that it can return to the engine and pull more heat from it.
The radiator can fail in a few ways. It can become so grimmy with deposits that it can no longer cool the engine all of the way. This is a likely scenario when your engine is running hot but not overheating. As time goes by, the radiator will only get worse until it can no longer cool the engine.
In this situation, you’ll need to take your radiator to a shop to have it repaired. Or, you can order a new one. Some people have success using a cure in a bottle cleaner.
4. Thermostat
Your F250’s thermostat is the gatekeeper that keeps the coolant from entering and exiting the engine. While a thermostat is perfectly capable of functioning for the whole life of the vehicle, it’s still a common reason that you can be running hot.
After the engine temperature reaches a certain level, the thermostat automatically opens up. This regulates the amount of coolant flowing through the engine. If the thermostat wasn’t there, the engine would always run cool. Heat is needed for efficient combustion, and for the heater to work properly.
Here’s more on Ford F250 thermostat diagnosis.
5. Water Pump
The water pump is the engine accessory that pumps the coolant through the F250’s engine. If it has a bearing fail on it, or when it is no longer being turned properly (bad serpentine belt), it won’t be able to pump enough coolant through your F250 and the engine will begin to run hot.
6. Debris
A common thing that can happen when driving on the interstate is picking up trash that blocks the radiator. Take a look around the front of your F250 and see if there is anything around it. You’re looking for a grocery bag, cardboard, or something large that would be blocking a decent chunk of the radiator.
Conclusion: F250 Running Hot
An engine that is running hot is a big deal. Good luck diagnosing your Ford F250. If there is anything that you would like to add, please leave a comment below.