Oxygen sensors play a vital role in both engine management and emissions control. When an O2 (oxygen) sensor go bad, it’ll cause your Toyota Sequoia‘s engine to run less efficiently.
Your Sequoia can exhibit symptoms when the Oxygen sensor has gone bad. Or, it may exhibit none at all. Often enough, the only sign of the problem at all is the service engine soon light being on.
The good news is, if you end up discovering that the oxygen sensor is bad, they really aren’t that expensive to replace.
Bad Oxygen Sensor Symptoms: Toyota Sequoia
Oxygen sensors can change the way that your Sequoia’s engine runs. Most of the time, the check engine light will come on. It’s a good thing that the check engine light would come on, as there is more than one oxygen sensor, and they can be difficult to get to and test.
The trouble codes associated with the OBDII scan will reveal which sensor is at fault and why it is bad (at least what the computer thinks is wrong). It is very rare for there to be a problem with an oxygen sensor, and not have the check engine light come on.
![Toyota Sequoia Bad Oxygen Sensor Symptoms](https://www.700r4transmissionhq.com/wp-content/uploads/2019/05/Bad-Oxygen-Sensor-Symptoms.jpg)
Here are the most common symptoms of a bad oxygen sensor in your Sequoia:
Service Engine Soon Light
More often than not, when an oxygen sensor in your Sequoia goes bad, it will throw a diagnostic trouble code. There are many oxygen sensor related codes.
These codes correspond with what side of the engine they are on (known as the “bank” for cylinder bank) and how far down stream they are. For instance, an oxygen sensor at bank 1 – sensor 1 would be:
- Bank 1- Side of the engine with the first cylinder in the firing order. This means that you need to look up the firing order for your particular model year and engine.
- Sensor 1- Sensor 1 would be the first O2 sensor in the line of sensors starting with the exhaust manifold and making its way back to the exhaust pipe. An Oxygen sensor that is between the catalytic converter and the engine is known as an “upstream” sensor. Oxygen sensors after the catalytic converter are “downstream sensors”. As a rule, the upstream sensor is more important for engine timing and air/fuel ratios.
By using a OBDII scanner you can determine exactly which sensor is bad, and what is wrong with it.
Loss In Fuel Economy
Your Sequoia’s oxygen sensors are responsible for helping to keep your engine running at optimal efficiency. The engine management computer uses the data from all of the O2 sensors to keep the air/fuel mixture optimized. A bad oxygen sensor can affect the mixture greatly.
Without being able to optimize the air fuel ratio, combustion isn’t as efficient, and fuel mileage suffers. There could also potentially be raw fuel that enters the exhaust. This fuel can hurt the catalytic converter.
Bad Smelling Exhaust
One of the most common symptoms that an oxygen sensor has gone bad is exhaust that does not smell good. The smell is often described as “rotten eggs” or sulfuric. Either way, like with rotten food, “the nose knows”.
Engine Running Rough
Without the proper air/fuel mixture, your engine won’t run as smoothly as it should. This is especially true if the mixture ends up too lean.
While a rough running engine can be a sign of a bad oxygen sensor, it is often a sign of a misfire as well.
Failed Emissions
Often enough, there won’t be any noticeable signs of a bad oxygen sensor. You’ll go to get an emissions check done, and your Sequoia fails the test. Without a check engine light, it can be tough to lock down exactly what would cause the vehicle to fail, but oxygen sensors are one of the more common causes.
Sequoia Bad O2 Sensor Symptoms & Causes: Conclusion
There may or may not be any noticeable symptoms when your Toyota Sequoia’s oxygen sensor(s) go bad. It is smart to use a scan tool to determine whether or not there is an OBDII trouble code associated with any of the sensors. Good luck diagnosing your Sequoia!