Subaru Liberty P0017: Crank/Cam Position Correlation – Bank 1 Sensor “B”

 

P0017 Subaru Liberty

P0017 in the Subaru Liberty is predominantly caused by a few different things. It is typically thrown when the Crankshaft Position Sensor and the Camshaft Position Sensor are out of alignment by a certain number of degrees, or if there is an issue with the wiring, or one of the sensors themselves may have gone bad. We’ll explore the symptoms and causes directly below.

P0017 refers to which camshaft position sensor is out of time with the Crankshaft. In this case it’s sensor “B”, Sensor “A” throws P0016

 

P0017 Symptoms: Subaru Liberty

P0017 should be considered an important trouble code to diagnose and repair. The crank and cam sensors work in tandem to produce the ideal air/fuel ratio for your engine. When this timing is off, the engine will typically not run (or barely run).

Here are the major symptoms of P0017 in the Liberty:

  • Failure to start
  • Rattle coming from the motor
  • Service engine soon light
  • Engine poorly running

 

P0017 Causes and Solutions: Subaru Liberty

Here are the most common causes of P0017 in the Liberty, as well as diagnostic advice, and resources to further explore. It’ll either be a wiring issue, or it’ll be a physical problem (bad reluctor or timing chain jumped).

 

Wiring Issues

One of the most common causes of P0017 in any vehicle is going to be wiring issues. You’ll want to inspect the wiring harness for visible damage. A lot of the harness leading to and from the Crank/Cam sensors is going to be exposed to hot exhaust and vibration. This is a great place to start diagnosing P0017 in your Liberty. It’s quick and easy to do this before moving on to the sensors themselves.

Make sure to check the harness where it plugs into both sensors as well.

How to Diagnose Vehicle Wiring Problems (AA1 Car)

 

Bad Sensors

After examining the wiring harness, it would be time to check the sensors themselves. Using a simple voltage tester, you’ll be able to determine whether or not they are functioning correctly. We linked to a great video showing you how to do so directly below.

How to test a crankshaft or camshaft sensor (YouTube)

Crankshaft Position Sensor (Amazon Low Price)

Camshaft Position Sensor (Amazon)

Timing

The timing chain or belt will throw cause P0017 to throw. This will happen when it has stretched or jumped a tooth or two. If it jumps more than a few teeth, the odds are that the engine itself will not run at all.

If you’ve recently changed the timing chain, it may very well have not been aligned properly on install. Many manufacturers (particularly Japanese Automakers) have very strict timing chain service intervals. If it’s been too long, it may jump a few teeth. Even the slightest misalignment can cause P0017.

Timing Chain Jumped Symptoms and Diagnosis

 

Crank or Cam Tone/Reluctor Ring

The Crankshaft Sensor is going to use a tone or reluctor ring to determine the position of the Crank. This ring uses notches that are scanned by the Crank Sensor in order to get an accurate position.

If this ring fails, the Liberty will not be able to get an exact crank position. The camshaft typically will have a ring that provides the same function.

Often when a reluctor ring goes bad, it’ll rattle quite a lot. That is a very good indication that there is an issue with it.

Here’s a good video on diagnosing P0017:

 

 

Conclusion

Good luck diagnosing P0017 in the Subaru Liberty. If there is anything you would like to add, please leave a comment below.