P0019 is a generic OBD II trouble code. It is typically thrown when the Crankshaft Position Sensor and the Camshaft Position Sensor are out of alignment by a certain number of degrees, if there is an issue with the wiring, or one of the sensors themselves may have gone bad. We’ll explore all the symptoms and causes directly below.
P0019 refers to which camshaft position sensor is out of time with the Crankshaft. In this case it’s sensor “B”. Sensor “A” throws P0017.
Ford Mondeo P0019 Symptoms
P0019 should be considered an important trouble code to diagnose and repair. The crank and cam sensors work in tandem to produce the ideal air/fuel ratio for your engine. When this timing is off, the engine will typically not run (or barely run).
Here are the major symptoms of P0019 in the Mondeo:
- Failure to start
- Rattle coming from the motor
- Service engine soon light
- Engine poorly running
P0019 Causes and Solutions: Ford Mondeo
Here are the most common causes of P0019 in the Ford Mondeo, and resources to help you diagnose the problem. It’ll either be a wiring issue, or it’ll be a physical problem (bad reluctor or timing chain jumped).
1. Wiring Issues
One of the most common causes of P0019 in any vehicle is going to be wiring issues. You’ll want to inspect the wiring harness for visible damage. A lot of the harness leading to and from the Crank/Cam sensors is going to be exposed to hot exhaust and vibration. This is a great place to start diagnosing P0019 in your Mondeo. It’s quick and easy to do this before moving on to the sensors themselves.
Make sure to check the harness where it plugs into both sensors as well.
How to Diagnose Vehicle Wiring Problems (AA1 Car)
2. Bad Sensors
After examining the wiring harness, it would be time to check the sensors themselves. Using a simple voltage tester, you’ll be able to determine whether or not they are functioning correctly. We linked to a great video showing you how to do so directly below.
How to test a crankshaft or camshaft sensor (YouTube)
Crankshaft Position Sensor (Amazon Low Price)
Camshaft Position Sensor (Amazon)
3. Timing
The timing chain or belt will throw cause P0019 to throw. This will happen when it has stretched or jumped a tooth or two. If it jumps more than a few teeth, the odds are that the engine itself will not run at all.
If you’ve recently changed the timing chain, it may very well have not been aligned properly on install. Many manufacturers (particularly Japanese Automakers) have very strict timing chain service intervals. If it’s been too long, it may jump a few teeth. Even the slightest misalignment can cause P0019.
Timing Chain Jumped Symptoms and Diagnosis
4. Crank or Cam Tone/Reluctor Ring
The Crankshaft Sensor is going to use a tone or reluctor ring to determine the position of the Crank. This ring uses notches that are scanned by the Crank Sensor in order to get an accurate position.
If this ring fails, the Mondeo will not be able to get an exact crank position. The camshaft typically will have a ring that provides the same function.
Often when a reluctor ring goes bad, it’ll rattle quite a lot. That is a very good indication that there is an issue with it.
Here’s a good video on diagnosing P0019:
Conclusion
Good luck diagnosing P0019 in the Ford Mondeo. If there is anything you would like to add that could help; the next person reading this article, please leave a comment below.